In the process of torquing the Let-Lok Compression Fitting (https://breezeautomotive.com/shop/ef...n-adapter-kit/) to the instructed 1 + 1/4 turns to the 3/8'' line (https://breezeautomotive.com/shop/19...th-3-8-outlet/) I seemed to have collapsed the line. The fitting didn't look to end up square and I tried loosening it, making sure the starting point was correctly squared when everything is just finger tight, and re-torquing again. But I think this process is what ended up curving and flattening the line itself.

I sent Mark an email with the pictures but also wanted to check with the forum. Did I f*** up and need to replace the sender or is this fine?


20230425_104932.jpg

20230425_104925.jpg

20230425_104858.jpg

20230425_104954.jpg