Rogier
02-09-2019, 01:16 PM
To install the factory turbo heat shield on the 818 we need the following tools.
Angle grinder or metal saw
10 mm spanner
and most important an engineer's hammer:D
101911
Start with cutting off the rear right part off the heat shield.
Then use you hammer to reshape the heat Shiel so the indent on the rear left goes completely across the heat shield.
Then use the factory brake to mount it to the exhaust.101913101914
Angle grinder or metal saw
10 mm spanner
and most important an engineer's hammer:D
101911
Start with cutting off the rear right part off the heat shield.
Then use you hammer to reshape the heat Shiel so the indent on the rear left goes completely across the heat shield.
Then use the factory brake to mount it to the exhaust.101913101914