tcollins
02-19-2018, 11:32 PM
I found a method to update the Coyote PCV hoses without breaking the bank and on a full set of AN fittings; especially the one that goes in the CHC for $140/pair! This seemed to work well so I thought I’d share.
I had extra AN10 hose laying around so I only needed to buy these Fragola E-Z clamps. After cutting the OEM tubing off the quick connects, I removed the O-ring. Next I slid the clamp onto the braided hose, then using the heat gun, warmed up the hose ID. It takes a little force but you can get the warm hose to fully engage with the plastic barbed connector. Tighten the clamp when in the desired position.
813198132081321813228132381324
I had extra AN10 hose laying around so I only needed to buy these Fragola E-Z clamps. After cutting the OEM tubing off the quick connects, I removed the O-ring. Next I slid the clamp onto the braided hose, then using the heat gun, warmed up the hose ID. It takes a little force but you can get the warm hose to fully engage with the plastic barbed connector. Tighten the clamp when in the desired position.
813198132081321813228132381324