engine/trannie mounts 818

[capt. bill]

Please advise why the motor mounts did not line up exactly; I really needed to force the alignment which I believe has contorted the rubber and may possibly result in failure of the mounts. Capt. Bill

[flynntuna]

I had to slot one of the transmission mount holes. Though I'm not using a standard engine.

[RM1SepEx]

I also slotted the trans mt hole, using std setup. I've found virtually every location that there is a slotted hole we run out of adjustment and parts don't align. Door latch, windshield, front lower control arms, trans etc...

That's what a die grinder is for!

[Mitch Wright]

I found that the Cusco mounts I am using the stud is offset, turned them around and the engine, transmission fell right into place.