throwout bearing

[rplourdejr]

I have these images I took of my throwout bearing. I think I attached them.

The bearing appears to move a little when it is installed.

Is this supposed to happen?

I cannot seem to get the clutch pedal to work, and I am not sure if it is because I cannot get the air out, or maybe this is why?

Anyone have any feedback on how this looks?

Thanks,

Rob

[AZPete]

Rob, the cutch pedal is limp until you fill and bleed the system. My pedal just went down and stayed there until I completed bleeding, then it worked fine.

[ssssly]

The throwout bearing will have play to it when installed.

If the pedal doesn't return to the up position, the culprit is air in the lines. Subaru clutches are notoriously a pain to bleed.

Just keep at it and eventually you will get pressure.