K3LAG
01-25-2015, 08:25 PM
Several folks, myself included, have broken the little plastic guide that snaps into the hole in the throttle pedal. I designed a replacement to be 3D printed. Depending on the tuning of your printer, you may have to trim it a bit. The smaller outer diameter is 8mm which is a hair larger than the hole in the pedal. I made it a bit big so I could adjust it for a friction fit. The slot for the cable is 1.5mm which is a hair smaller than the cable, but you should be able to work the cable through it. The hole in the middle is a bit larger than the cable.
My printer still needs a little tuning and it tends to over extrude so I ended up with undersize inside diameters and oversize outer diameters.
I'd be happy to provide a copy of the .stl file for anyone that would like it. If someone has a place they could host it that would be nice too.
Make sure when you install this piece that you keep the slot turned a different direction from the slot in the pedal to ensure the cable doesn't slip out. ;)
38089
Larry
My printer still needs a little tuning and it tends to over extrude so I ended up with undersize inside diameters and oversize outer diameters.
I'd be happy to provide a copy of the .stl file for anyone that would like it. If someone has a place they could host it that would be nice too.
Make sure when you install this piece that you keep the slot turned a different direction from the slot in the pedal to ensure the cable doesn't slip out. ;)
38089
Larry