Exhaust trim

[Quiny]

Did anyone get the aluminum trim that attaches to the rear bumper that the tailpipe goes through? I see it on the FFR cars but I don't see one in my kit or on the parts list.

[metalmaker12]

Mike Everson has them.

http://replicaparts.com/GTM%20exhaust%20trim%20ring%20page.htm

[michael everson]

Quiny. I haven't seen it either, but if I find it. I will give you mine.
Mike

[RM1SepEx]

It is not a part of the FFR kit

[michael everson]

Quiny. Maybe I could use your car to design one?
Mike

[Quiny]

Quiny. Maybe I could use your car to design one?
Mike

Sounds like a great idea, the car is available to you anytime and let me know what I can do to help.

[C.Plavan]

I just ordered a trim ring from Mcmaster Carr. I bought a few to try out. They will work fine, I just have not mounted it yet. You just need to powdercoat or paint with high temp paint. ~$4 to ~$6 w/wo holes (With holes I like better). Choice of steel or galvanized in 3".

http://www.mcmaster.com/#angle-rings/=vdluyz

[C.Plavan]

Here is a picture of the $4 trim ring mocked up. I still need to paint it, then rivet it on (with backing washers). Then I can remove the silicon gobs too. lol
http://i.imgur.com/U93NW2Yl.jpg?1

[CU9DZ]

Hi Quiny. What are you using for an exhaust? are you putting in a cat and muffler? We need to keep the state and EPA happy.
Dave

[naigvirr]

I just ordered a trim ring from Mcmaster Carr. I bought a few to try out. They will work fine, I just have not mounted it yet. You just need to powdercoat or paint with high temp paint. ~$4 to ~$6 w/wo holes (With holes I like better). Choice of steel or galvanized in 3".

http://www.mcmaster.com/#angle-rings/=vdluyz

Thanks very much for the tip. I’ve just placed order with McMC.