View Full Version : O-ring identification
DMC7492
08-16-2014, 06:45 PM
Hi guys I purchased a complete engine gasket set for a 2005 WRX! There are a few O rings I cannot find a location for, does any body have experience as to where these O rings go? I have identified the lower right seal as the front crank seal that is pressed into the oil pump housing.
32561
Mechie3
08-16-2014, 06:49 PM
Lower left looks like the oil fill cap. Its has a squarish profile.
Goldwing
08-16-2014, 11:02 PM
Top middle might be the oil cooler-to-engine block gasket?
DMC7492
08-17-2014, 06:33 AM
Mechie, that is correct, oil filler cap for the brown square cut seal.
The red one is much smaller than the oil cooler to block seal.
ssssly
08-17-2014, 07:49 AM
Top left: Oil Cap
Top middle: Water crossover (should be two of them)
Top right: Could be many things. My guess is internal oil filler neck.
Bottom left: Looks like a non AVCS cam seal. Should be two or four of them depending on the kit. Should have a part number stamped into it.
Bottom right: Front main oil pump seal or AVCS cam seal. Hard to tell without a proper size reference. Should also have a part number stamped into it.