Clutch

[FFRSpec72]

Not into spending lots of $$$ on a clutch as I run my challenge car on a $99 Ford Racing clutch and pressure plate for over 2 seasons and no issues, I just replace it when I refresh the engine. Not a lot of need for a heavy duty clutch in road racing with a stock STi engine. So I was looking at the Exedy KSB03 and I assume this will also fit a JDM engine? I'm going to keep the original flywheel.

[Ravendas]

If it's the 5spd transmission, it should fit just fine.

[philly15]

you always match the clutch and flywheel to the trans for subarus, so i would look into what flywheel you have and go from there

[bossman43]

you always match the clutch and flywheel to the trans for subarus, so i would look into what flywheel you have and go from there

Just to be certain, if I have a 2.5l '06 STi engine and an '06 WRX 5-speed, both the clutch and flywheel should be for the '06 WRX 5-speed? For example, Exedy lists their FF501 flywheel for use with the STi (EJ257) engine and their FF502 flywheel for use with WRX (EJ255). I should use the clutch AND flywheel for my WRX 5-speed application? Confirmation is appreciated.

Thanks,

-Mike

[metalmaker12]

H
Just to be certain, if I have a 2.5l '06 STi engine and an '06 WRX 5-speed, both the clutch and flywheel should be for the '06 WRX 5-speed? For example, Exedy lists their FF501 flywheel for use with the STi (EJ257) engine and their FF502 flywheel for use with WRX (EJ255). I should use the clutch AND flywheel for my WRX 5-speed application? Confirmation is appreciated.

Thanks,

-Mike

Your correct, the flywheel and clutch has to mate to 5 speed