Midwest Classic Insurance

Visit our community sponsor

25th Anniversary MK4 "Quarter Past Half Time Machine" Build: Inner cockpit Driver & Pa

Again, complete focus to keep the heat out and also have these parts show in aluminum keeping with my theme to show more aluminum in the cockpit.

  1. Another view of bracket being added.

  2. Driver side outer wall added.

  3. Passenger side outer lower backet added to close out all heat access from side pipes.

  4. Inner view of passenger side. (*Note: I started to drill and then realized I would've been way-off. I had to reset and move the "X" to make sure I...

  5. Lower angle bracket prior to attachment.

  6. Bracket drilled and cleco'd to the outer side wall.

  7. Prior to installation.

  8. Holes drilled for seat belt bolt access and seat heater wire.

  9. Another view of closed-in e-brake opening.

  10. Drivers side outer wall closed-in.

  11. Top view of the outer wall sandwich

  12. Passenger side view of outer wall.

  13. Closing up the driver side opening.

  14. Pre-drilling.

  15. Cleco'd and closed-up.

  16. Rear driver side seat belt view.

  17. Plan to add to grommets.

  18. Scrap aluminum.

  19. Pre-fitting.

  20. Closing up the parking brake opening.

  21. Cleco'n it closed.

  22. That will work nicely.

  23. My plan was to add an inner & outer skin to keep out the heat and show more aluminum in the cockpit.
Showing photos 1 to 23 of 23

FFMetal

Visit our community sponsor