Forte's

Visit our community sponsor

Skinning Transmission Tunnel with Carbon Fiber

  1. Final product

  2. Final Product

  3. Caption

  4. First coat clear matte with a little more work

  5. 800 grit wet sand before hole cut out and clear coat

  6. All Photos 1 of 1 (4)After cutting the holes and 800 grit sanding before the matte clear coat. I dampened the tunnel to pop the carbon fiber out.

  7. All Photos 1 of 1 (3After cutting the holes and 800 grit sanding before the matte clear coat. I dampened the tunnel to pop the carbon fiber out.

  8. All Photos 1 of 1 (2After cutting the holes and 800 grit sanding before the matte clear coat. I dampened the tunnel to pop the carbon fiber out.

  9. Continuing sanding with a block. Getting closer.

  10. Beginning sanding the resin with 160 grit and a sanding block knocking down the high spots and seeing if I need to give it another coat of resin.

  11. After 3 coats, sanding down with 160 grit and then a light coat of epoxy resin. The light does not do it justice at this point. Will sand again and...

  12. All Photos 1 of 1 (5)

  13. Initial placing of the Carbon Fiber on the tunnel

  14. All Photos 1 of 1 (2)

  15. All Photos 1 of 1 (1)

  16. All Photos 1 of 1

  17. All Photos 1 of 1 (3)

  18. All Photos 1 of 1 (2)

  19. All Photos 1 of 1 (1)

  20. All Photos 1 of 1
Showing photos 1 to 20 of 20

FFMetal

Visit our community sponsor