Coyote EFI Harness Fusel Panel Bracket - Logo Reversed???

[32J]

Just wondering if anyone else has had this same 'cosmetic' problem. The Coyote Fitment instructions are simple enough: locate the fuse panel mounting bracket with the logo, and mount to the passenger side footbox:

Screenshot 2022-05-23 123438.pngScreenshot 2022-05-23 123513.pngScreenshot 2022-05-23 123525.png

The problem? This is what I received in my kit:

20220523_123050.jpg

Was this just a bending error with the bracket (i.e. bent it the wrong way), so now the logo is backwards? Or, did they intend that the bracket be turned 180° so that the panel mounts further back, like this?:

20220523_124136.jpg

I have a heater at the firewall so I can only get the box so close. Don't want to start drilling until I know the harness will reach all the right spots.

Thanks,

32J

[JeffP]

Yes yours is bent backwards. I have one I’m not using, I mounted mine to the firewall. It has a light coat of black vht paint on it but you’re welcome to it for shipping.
197B3C3D-C33C-445A-9BB7-F0B55408B354.jpg

[Lidodrip]

Yours was bent the wrong way, I had the same issue. I mounted the control box to the firewall and then modified the bracket as a mount for my brake/clutch reservoirs (Scott’s Hotrod Triple).

[Tbev]

I also mounted mine to the firewall and used that bracket to support the heater bypass.

[32J]

Thanks, but I think I'll try and come up with a work-around. Showing the logo is not high on my wish list.

[32J]

Do you have wiper motor as well? I'd be interested to see where you placed the EFI fuse box in relation to the heater fan and the wiper motor. Thanks!

[Lidodrip]

Yours was bent the wrong way, I had the same issue. I mounted the control box to the firewall and then modified the bracket as a mount for my brake/clutch reservoirs (Scott’s Hotrod Triple).

Here is how I repurposed my bracket:

[32J]

Would you have a picture of where you mounted the Coyote fuse box? I have a wiper motor and heater as well. Thanks.

[Lidodrip]

Would you have a picture of where you mounted the Coyote fuse box? I have a wiper motor and heater as well. Thanks.

I mounted my fuse box on the firewall/driver's side. I attached it to the cross beam after tapping some holes. It seems to work well there, plenty of clearance and the cables are long enough to reach the PCM. I have wipers (Specialty Power Windows), but do not have a heater. I don't think this location would interfere with either. I am not using a master power cut off switch, but I think this location would work well if one did decided to use a switch.



Good luck,
James

[JeffP]

I have a heater, wipers, and coyote and mounted mine similar to James, just a little higher up.