Searching for bezel on dash

[VeniceCobra]

Hi everyone

After searching the web for couple hours, I'm surrounding to your knowledge…

I'm installing the air vent kit from Finish Lines, and the pull type knobs came with no bezels, and they don't carry these in store.
So, I'm looking for 2 bezels like the one shown in the picture.

The inner diameter hole is about 3/8 (if smaller, I could always enlarge it) but it cannot be 1/2 as the cable of the knob will go through
The bezel's design has a groove crossing it

Do you know where I could find these?
Does anyone who may have some, would like to sell/trade?

Patrick

Dash.jpg

[JIMOCO]

20160313_131201.jpg20160313_131243.jpg
Try Toms Bronco Parts. https://www.tomsbroncoparts.com/cate...ronco-switches
Scroll Down. I found a bezel for all of my switches. I had to widen some holes and flatten the back. I used JB weld to attach the ring from the switch to the back of the bezel (excepts lights) and screwed tem on the switch,

[BEAR-AvHistory]

I used the same bezel. They are a commodity item made in China & you can get them from a number of vendors that do old FORD trucks & Broncos. Think some Mustangs also had them. Prices are all over the place so shop around. Just note some times low prices are jacked up with high shipping charges.

[VeniceCobra]

Jimco and Bear, thank you very much, greatly appreciate.