Hello everyone. I purchased a GEN 4 combo from Factory five and need some assistance with the throw out bearing.

I have everything installed and this is the last step and I am having a hard some of understanding what is going on with it. I would upload a picture but I am unable to do so with my phone. It appears the throw out bearing is a "floating" assembly and freely rotates on the splined hub. The lines are coming out of the bottom and are not vertical which are making it almost impossible to bleed. I am unable to get pressure or a good bleed on the system. Is this a common issue or did factory five mess up the installation? At this time I have not been able to get a hold of them.

Thank you.