Hi - I have the carbon fiber dash with the drop-section for the ignition, heater, wiper, etc... I also have the Russ Thompson turn signal system. The carbon fiber dash instructions don't talk about alignment with the top 3/4" square tube. In the general roadster instructions, however, the (aluminum) dash instructions state: "Line the dash up with the hoop on the chassis. The corners of the dash support tube are 3/16” below the top edge of the dash. The tube will be lower as it goes to the middle."

Question: Would anyone know if this is same guidance for the carbon fiber dash? Should I place it so that each corner is 3/16" higher than the 3/4" square tube behind it?

I've made a template from 1/8" MDF, so I'd like to clamp it as close as possible to what the carbon fiber dash will require. I'll then be able to measure for the center of the steering column with the RT turn signal system.

Thanks!

32J