Coyote Gen 3 Touching Drivers Side Footbox - Suggestions?

[32J]

Hi - My first build and we just finished installing the Gen 3 Coyote with Tremec TKX. I installed the motor mount spacers, both sides, per instructions. The transmission looks to be lined-up (by eye) with the rear diff. About 1" clearance between the valve/ignition cover and the passenger side footbox. But on the drivers side, the valve / ignition cover is touching the footbox. The one header pipe is 1/4" away from the corner of the footbox, at most. Normal?

20220705_175653.jpg20220705_175645.jpg

I put level on the underside of the oil pan, and compared it to the main 4" tube running across the engine bay. It seems that the right bank (PS) is slightly higher than the left bank. Again, not sure if this normal or not, but I would think you would want everything level.

Any suggestions or advice?

Thanks!

32J