I'm a few months away from installing my Coyote Gen 3. Just wondering if people have had a tough time installing the long-tube Coyote headers once the engine is sitting on the mounts, or, if installing the headers while the engine is still hoisted (but only a few inches off the mounts) is a lot easier. I'm asking because I have bad arthritis in my right shoulder (my left shoulder is already 'new'), so I'd like to avoid awkward tightening if I can help it. Same question on the KRC power steering kit: would it be safe to install this before lowering the engine in, or is it easier to install the kit after the engine is in?

Thanks,

32J