Infinitybox

Visit our community sponsor

Thanks Thanks:  2
Likes Likes:  5
Results 1 to 24 of 24

Thread: hydraulic clutch master cylinder - do I trim the push rod?

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-19-2020, 11:53 PM #1
    toadster
    toadster is offline
    25th Anniversary #9772 toadster's Avatar
    Join Date
    May 2011
    Location
    Folsom, CA
    Posts
    1,936
    Post Thanks / Like

    Question hydraulic clutch master cylinder - do I trim the push rod?

    I purchased the 13/16ths wilwood master from Mike Forte for the hydraulic clutch (pending with engine/trans purchase) - but I want to setup the pedalbox prior to the full setup
    I cannot seem to find any directions for modifications of the master cylinder, some posts say they trimmed the push rod...

    any guidelines here?
    Last edited by toadster; 05-20-2020 at 05:53 PM.
    Todd
    25th Anniversary MkIV | #20 of 25 | Build #9772
    https://cobradreams.com/ <- my build!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

FFMetal

Visit our community sponsor