Wondering if anyone knows the specs or supply for the small socket head set screws for the stock spinners. One of mine is rounded-off. I think it's 10-32, but the end has tip that is not the same as usual set-screws.
Thanks,
32J
Printable View
Wondering if anyone knows the specs or supply for the small socket head set screws for the stock spinners. One of mine is rounded-off. I think it's 10-32, but the end has tip that is not the same as usual set-screws.
Thanks,
32J
Conventional wisdom is to throw out those set screws and just thread them correctly. With the spinners on the correct side, the knock offs will only tighten when moving forward. The set screws will only possibly mess up the threads. I might have mine in an extra parts box if you really want them
Makes sense. Thought the set screws were there to replace the old safety wire method. Not having them would galling the threads if someone tried to knock off the spinners without knowing about the set screws.
Yep, throw them away. If you have them on the correct sides of the car forward movement naturally wants to tighten them. Regarding the correct side: Right hand threaded spinner goes on the LH side of the car and left hand thread goes on the RH side of the car. Just remember that when tightening the spinner they rotate towards the rear of the car.
Jeff
Question - if they were replaced with nylon-tipped set screws like these, would that alleviate the concern about possibly galling the threads, while still giving some added level of security?
https://www.mcmaster.com/set-screws/...-set-screws-9/
I was considering epoxying the center hub inside the wheel. Has anyone considered this or found another way to fix the center threaded hub inside the rim. I have heard that some use noodles to hold the center in place so you can thread the spinner on
Noodle behind the center piece and silicon O rings to keep it from moving when unthreading the spinners
You may need to clean up the threads on the hub to get the spinners to screw on smoothly, I gave them a light clean up with emery cloth. I also use dry graphite to lubricate the threads.
David W