TKX Wiring for Coyote

Would anyone have a schematic or advice on connecting the clutch safety sensor and the reverse brake lights on the Tremec TKX? Connecting the speedo was easy because the Ron Francis rear harness already had the plug. In the pedal box, I already connect the clutch safety wires to the cylinder plunger switch, per instructions. But I can't find any instructions or wiring diagrams that talk about the clutch safety switch at the transmission itself. Same for reverse brake lights.

Thanks,

32J

The clutch safety switch interrupts the starter and doesn't go to or through the transmission. For the backup light, there is a plug on the trans. You can buy the pigtails/plug connector from various sources.

https://www.cjponyparts.com/modern-d...xoCFswQAvD_BwE

Quote:

---

Originally Posted by Papa

The clutch safety switch interrupts the starter and doesn't go to or through the transmission. For the backup light, there is a plug on the trans. You can buy the pigtails/plug connector from various sources.

https://www.cjponyparts.com/modern-d...xoCFswQAvD_BwE

---

For the clutch safety connector on the trans, would you suggest that I just terminate the wires or tape it off (or shunt the wires if it's a normally open switch)?

Thanks!

Are you talking about the neutral safety switch? I just left that plug on the harness and zip tied it to keep it out of the way.

Just to make sure it's clear, the Coyote control pack harness comes with a clutch safety switch. Doesn't involve the Ron Francis blue start wire or the transmission. Just wire it like the Ford and FF instructions show. Tie the blue RF wire intended for the safety switch out of the way or remove. Doesn't matter if the two ends (where the switch would normally go) are tied together or not. They're not in the circuit when the Coyote switch is used.

Quote:

---

Originally Posted by edwardb

Just to make sure it's clear, the Coyote control pack harness comes with a clutch safety switch. Doesn't involve the Ron Francis blue start wire or the transmission. Just wire it like the Ford and FF instructions show. Tie the blue RF wire intended for the safety switch out of the way or remove. Doesn't matter if the two ends (where the switch would normally go) are tied together or not. They're not in the circuit when the Coyote switch is used.

---

Thanks, Paul. I didn't realize that. Sorry for giving bad info.

Dave

Quote:

---

Originally Posted by 32J

Would anyone have a schematic or advice on connecting the clutch safety sensor and the reverse brake lights on the Tremec TKX? Connecting the speedo was easy because the Ron Francis rear harness already had the plug. In the pedal box, I already connect the clutch safety wires to the cylinder plunger switch, per instructions. But I can't find any instructions or wiring diagrams that talk about the clutch safety switch at the transmission itself. Same for reverse brake lights.

Thanks,

32J

---

I am pretty sure the reverse light is just a normally open switch, right? (I didn't use it)
You just run your lead though it and when its not in reverse the contact isn't made and no current passes through then when you are in reverse it competes the circuit.

Thanks, everyone!

32J