Would an 8.8 rear end from a 2000 Ford Explorer work?

Printable View

06-15-2022, 06:56 AM
Cansler

Would an 8.8 rear end from a 2000 Ford Explorer work?

Could I use the rear end housing from a 2000 Ford Explorer, rebuild it, and put in some Moser 5 lug axles? I'm looking to source a 5.0 engine from a 2000 Ford Explorer, so I'll have the rear end as well, if it fits.
06-15-2022, 07:11 AM
Jeff Kleiner

No. Wrong mounts, wrong width and wrong pinion offset.

Jeff

All times are GMT -5. The time now is 03:14 PM.

The representations expressed are the representations and opinions of the TheFactoryFiveForum.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Factory Five Racing, Inc. or Ford Motor Company.
This website has been planned and developed by TheFactoryFiveForum.com and its forum members and should not be construed as being endorsed by Factory Five Racing, Inc. or Ford Motor Company for any purpose.
"FFR", "Factory Five", "Factory Five Racing", and the Factory Five Racing logo are registered trademarks of Factory Five Racing, Inc.
TheFactoryFiveForum.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s).
Thank you for visiting the TheFactoryFiveForum.com.
Copyright 2011 Factory Five Racing, Inc. All rights reserved.
COBRA is a registered trademark of the Ford Motor Company. The Factory Five Forum is not connected to the holders of this mark.
The Factory Five Forum is not connected in any way to Carroll Shelby.