Printable View
Anyone know if this is normal? TR3650 5 speed, replaced clutch and throw out bearing before installing trans. The clutch fork doesn’t engage the throw out bearing until there is only about a 1/2 inch of clearance left between the fork arm and the bell housing (see pics).Attachment 130245Attachment 130246
Sounds like you have too short of a clutch pivot ball.
Make sure the throw out bearing is installed correctly too. https://www.google.com/search?rlz=1C...uRggfPu7uoBA29
I didn’t realize there were different lengths on the pivot ball. Note this engine transmission combo came directly out of a 2002 donor. As far as I know the clutch was supposed to be a direct replacement.