BluePrint Engines

Visit our community sponsor

View RSS Feed

Recent Blogs Posts

  1. First Day- new kit on the block

    by
    mgibson020
    , 12-24-2022 at 03:52 PM
    Received my kit on 23rd December 2022. Christmas came early

    [ATTACH=CONFIG]177168[/ATTACH]

    Ordered my kit in February, and expected to get a partial kit due to supply chain difficulties. Actually, i got most things other than some interesting gaps, like the gauges for instance or the door latches. Enough to get started. i fully inventoried my kit and found only one very small difference from what was there and what FFR said was there. Took about 7 hours to inventory ...
    Categories
    Uncategorized
    Attached Thumbnails Attached Thumbnails Click image for larger version.  Name: first picture.jpg  Views: 68  Size: 399.8 KB  ID: 177168  
    Comments 0 Comments
    Read MoreRead More

  2. 4.6L Oil Pan suggestions

    by
    troberts6494
    , 12-13-2022 at 02:32 PM
    Hello I am building a Roadster with a 4.6L out of a donor police Crown Vic. her at Midland College in Midland TX. I have stepped into this build and noticed the factory engine oil pan hangs way below the frame rail. We have a tight budget and looking for suggestions on which pan to use. I was going to cut and modify my factory pan and pickup, but time is short. Any suggestions would be much appreciated.
    Categories
    Uncategorized
    Comments 0 Comments

  3. Ride height

    by
    jwd
    , 12-09-2022 at 09:57 PM
    Looking at ride height posts and the general opinions are 4 to 4/1/2 front 4 1/2 to 5 rear. I’m running 15 inch 60 series tire with pretty tall sidewalls. I think if I crank the springs down to those heights I won’t have any spring left. Am I missing something or is my feeble mind not firing on all the brain cells?
    Categories
    Uncategorized
    Comments 1 Comment

FFMetal

Visit our community sponsor