All Blog Entries

Going from GT40P heads even if they are ported to aluminum heads is going to be a vast improvement for my performance plans. My self imposed budget is based on being a poor hot rodder which has caused the habit to stick. I'm starting with a set of Victor Jr clones that are bare "as cast". My initial inspection and evaluation of these is good to very good. There are defects as with any "as cast" product. The defects, parting lines, and other rough areas will be smoothed an ...

Attached Thumbnails

   

818R project for sale in SO CA, pm if interested.

[ATTACH]39112[/ATTACH][ATTACH]39113[/ATTACH][ATTACH]39114[/ATTACH][ATTACH]39115[/ATTACH][ATTACH]39116[/ATTACH][ATTACH]39117[/ATTACH]

Attached Images

• IMG_0010.JPG (1.23 MB, 513 views)
• IMG_0012.JPG (1.54 MB, 545 views)
• IMG_0009.JPG (1.62 MB, 552 views)
• IMG_0013.JPG (1.57 MB, 490 views)
• IMG_0022.JPG (1.16 MB, 510 views)
• IMG_0031.JPG (1.17 MB, 548 views)

Just had to post this bit of news. As far as I , and the folks at Stainless Steel Headers know, this is the first time using their headers in a Coyote/coupe build.
They fit beautifully.

[ATTACH]34105[/ATTACH][ATTACH]34106[/ATTACH]

Attached Images

• September post-18.jpg (438.0 KB, 549 views)
• September post-17.jpg (459.7 KB, 540 views)

Got to look at the kit today! "Triathletedave" invited me over to see his 818s build and nope I'm not fitting in a stock configuration... So my tank is going in the front like Bob_n_Cincy's build. If only they stretched the kit about 4" more.

I would recommend any big and tall guy to test fit first...

Was very impressed with the kits build quality and was equally impressed with Dave's progress with the kit.

Thanks again Dave!
F ...

09/13/2014 Purchased a 2002 Impreza 2.5l NA with 5 speed. $1600.00 Let the fun begin! ;)

[ATTACH=CONFIG]33526[/ATTACH][ATTACH=CONFIG]33527[/ATTACH][ATTACH=CONFIG]33528[/ATTACH][ATTACH=CONFIG]33529[/ATTACH][ATTACH=CONFIG]33530[/ATTACH][ATTACH=CONFIG]33531[/ATTACH]

Attached Thumbnails