Rat Eater Build
Chassis Wiring
by , 12-28-2011 at 10:39 PM (1060 Views)
it's been a while since my last post, but, as I found out, wiring takes a lot of time. Well, not actually running the wires, but debating where to run it, to make it less visible.
Here are some pictures from what I have so far....
My neighbor came over the other night and welded ground studs:
[ATTACH=CONFIG]7049[/ATTACH][ATTACH=CONFIG]7050[/ATTACH][ATTACH=CONFIG]7051[/ATTACH]
Fuse panel is above the pedals
[ATTACH=CONFIG]7052[/ATTACH]
Most of the wiring comes through driver footbox side wall. I used rubber grommets to prevent any wire damage in the future.
[ATTACH=CONFIG]7053[/ATTACH]
Heater control wires, seat heaters, stereo cables, fuel pump harness and rear lights harness placed inside transmission box and then ran to all accessories
[ATTACH=CONFIG]7054[/ATTACH][ATTACH=CONFIG]7055[/ATTACH]
Seat heaters wires waiting for seats:)
[ATTACH=CONFIG]7056[/ATTACH][ATTACH=CONFIG]7057[/ATTACH]
Front lights, horn and cooling fan harness hidden behind frame, so with body is on I won't be able to see it:)
[ATTACH=CONFIG]7058[/ATTACH]
Tags:
None
- Categories
- Uncategorized
Email Blog Entry
Go to Profile
Mark as Read
