Rat Eater Build
Cockpit aluminum panels
by , 11-22-2011 at 08:16 PM (1096 Views)
I just spent two days working on aluminum panels. Every piece came out really nice and the best part is- I didn't cut my fingers even once. I believe that my 2 years HVAC experience helped here:)
Here is passenger footbox and floor
[ATTACH=CONFIG]6304[/ATTACH][ATTACH=CONFIG]6306[/ATTACH]
Driver side didn't close complete, just because I will need access pedal area to install fuse box and run a lot of wires.
[ATTACH=CONFIG]6307[/ATTACH]
Rear panel left with clekos and not riveted in yet. I'm trying to figure out where I could mount couple of speakers. For speakers placement I had to pull a seat from the attic.
[ATTACH=CONFIG]6308[/ATTACH][ATTACH=CONFIG]6309[/ATTACH]
Tags:
None
- Categories
- Uncategorized
Email Blog Entry
Go to Profile
Mark as Read
