DanQ
Engine turned dash and firewall.
by , 07-10-2023 at 09:21 PM (475 Views)
A few weeks ago I researched how to set up an engine turning (or jeweling) jig. After a few trials, I believe I accomplished what I was hoping for. Has anyone else done their dashboard or firewall in this pattern? Afterwards, I gave it three coats of clear to help keep it clean. Total cost was under $20, but a lot of labor to set up and burnish close to 750 swirls between these two pieces.
[ATTACH=CONFIG]187101[/ATTACH][ATTACH=CONFIG]187102[/ATTACH][ATTACH=CONFIG]187103[/ATTACH][ATTACH=CONFIG]187104[/ATTACH][ATTACH=CONFIG]187105[/ATTACH]
- Categories
- Uncategorized
Email Blog Entry
Go to Profile
Mark as Read
