Diffuser stake panel

[sressue]

Getting to the end of my build and came across four aluminum panels, two marked 25682 and two marked 25683. All named diffuser stake panels. I have found nothing in the manual that says how to install them. I assume they go on the sides of the difusser. Any help on how they install would be appreciated. I have GTM #333 that is a Gen2.

Thanks, Steve

[The Stig]

Hi Steve,

See if this is what you're looking for. They're riveted in place. Just space the rivets 1 1/2 to 2 inches apart.

http://i210.photobucket.com/albums/bb94/jmichaelbaskin/DSC_1061.jpg

Take Care,

Mike

[sressue]

Mike, they don't look like the ones I have. My diffuser has no cutouts. Here is a picture of what I have.
Steve

15628

[Fraser D]

you have the correct ones. Mike has added a set of Shane's louver inserts either side of the center strake.

[sressue]

you have the correct ones. Mike has added a set of Shane's louver inserts either side of the center strake.

Dave, do you know where and how they are installed?

Steve

[Fraser D]

Dave, do you know where and how they are installed?

Steve

I have not even considered mounting those just yet but will in the next couple of weeks.
They do look equally spaced and I don't know if there is anything in the manual or not.