racephotoman
01-19-2013, 02:24 PM
While I think I might know the answer to this, I just wanted to check if my thinking is correct. I switch to the CASEY DESIGN dash setup, had it powder coated and now installing. Figured to temp install the doors as well to see that the dash indeed fits before installing the gauges (also knowing I still will need to final adjust it slightly after the body is also temp. installed). Anyway, looking a the driver's side and passenger's side pic, the curved part of the dash just makes it under the door on the DS, while the dash sits slightly above the door line on the PS (I'm calling these equal - and in both cases not good).
Looking back at the FFR supplied dash, I see the metal height measurement where you bend the dash is much less - so the obvious question, I should have (and have to) cut/sand the CASEY dash's ends to match the FFR proportion so the curved end will easily fit under the doors and body?
Walter
14528
14529
Looking back at the FFR supplied dash, I see the metal height measurement where you bend the dash is much less - so the obvious question, I should have (and have to) cut/sand the CASEY dash's ends to match the FFR proportion so the curved end will easily fit under the doors and body?
Walter
14528
14529