Casey Design Dash Question

[racephotoman]

Installing the Casey Design dash (or actually can be the standard FFR dash) - does anyone know if you make flush the aluminum dash's highest point with the apex of the car's dash frame loop? If this makes sense. I basically don't want to drill any holes in the wrong place.

The second part of this, would the dash's bent ends rest to the inside (of the car) of the door hinge bracket's flange that's welded to the square tube (and running parallel with the dash) - I hope this description makes sense.

Any rough install pic would be helpful...thanks, Walter

14466

[cgundermann]

Question #2 first, yes - the ends of the dash are bent to to be retained by the frame piece you are pointing to. After i bent per the FFR directions, i put a rivet on the dash on the outside of the dash's touch point to the frame edge as bump stop. For the the final placement, I would recommend velcroing it place until the final body fitment and then adjust accordingly depending on the interface with the body.