Front body bolts spacers

[Gopher]

I posted this question on the other site as well but can some one tell me what spacers go where on the front mounting bolts. I know I seen it posted before even wrote it down but I cannot find the note book. So could someone please tell me what spacer goes where.Thanks in advanced.

[Jeff Kleiner]

Here ya' go Bill!

Mk4 front quickjack sleeve lengths:
RH upper=2 5/8" inside; 3 1/8" outside
RH lower=2 1/8" inside; 3 1/4" outside

LH upper=2 5/8" inside; 3 1/8" outside
LH lower=2 1/16" inside; 3 5/8" outside

Cheers,
Jeff

[Gopher]

Thank You very much Jeff .

[Slider]

Can you post and let me know if your spacers actually are the same size? I found that mine are different... just curious. THanks

[Gopher]

OK my spacer are 2 at 2-5/8
2 at 2-7/8
1 at 2-1/16
1 at 2-1/8
1 at 3-1/4
1 at 3-5/8
Hope this helps you .

[GWL]

Okay, to understand these numbers I had to rearrange them.

Gopher's..........Jeff's
1 at 2-1/16.....1 at 2-1/16
1 at 2-1/8.......1 at 2-1/8
2 at 2-5/8.......2 at 2-5/8
2 at 2-7/8.......2 at 3-1/8
1 at 3-1/4.......1 at 3-1/4
1 at 3-5/8.......1 at 3-5/8

I'll measure mine. I've got the first Mk4, so it will be interesting to see what they are. I've mounted mine but were not happy with the fitting and was working on making my own but quit when I had problems fitting my front bumper too. I was going to revisit it later.

George

[Gopher]

I simply put the 2-7/8 where the 3-1/8 were to go and everything worked fine. The bumper even lined up good on the first try.

[GWL]

I simply put the 2-7/8 where the 3-1/8 were to go and everything worked fine. The bumper even lined up good on the first try.

Actually, I got the two bumpers mounted Okay, but the nudge bar in between just does not fit. The angles of the mounting on the nudge bar are way off.

George