FF Tech
What do you suggest for torque spec for a Coyote engine.
1. Flywheel to engine, do you use Blue Loctight
2. Pressure plate to Flywheel
Thanks
Hammink Performance
01-02-2013, 03:41 AM
Hi Dan,
On our Coyote we used blue loctite on the flywheel bolts, and this is the torque spec we used.
flywheel to crank bolts 2 stages 177 lbins / 60 degrees
(it was a long time ago and I did not find a source for the spec I wrote down so it would be nice if someone here could verify what I just wrote)
(the car has only been racing, and the flywheel never came of so we should be good :-) )
The clutch we mounted was from centerforce, and it came with specific centerforce specs so I am not sure if they will help you.