Upper Control Arm Sleeves

[gofastoldguy]

Gents: I have to replace the Caster sleeves on Mk II chassis and notice they are bigger in diameter than the ones sold at Speedway, SPC. Summit.
They look to be 3/4 I.D. instead of 5/8". Is that correct? Can u advise where to get 5" long sleeves? Thanks
Bill Bryan

[gofastoldguy]

14240FFR Tech...refer to my previous post. I found these 5" sleeves on Summit, they are 3/4x16 threads by Allstar. Anodized Steel. Is this the thread size for the older upper control arm?

[napatom]

Hi Bill,
i measured mine and they are 3/4". I am ordering today.
Tom