Coyote torque specs

[DANW]

I'm looking for torque specs for my coyote build.
1.Fly wheel do I need blue locktite?
2. Bell housing to engine?
3. Pressure plate to Fly wheel?
4. Tremec to rear bell housing?

Thanks much

[Jester]

I'm looking for torque specs for my coyote build.
1.Fly wheel do I need blue locktite?
2. Bell housing to engine? 35 ft lb
3. Pressure plate to Fly wheel? 33 ft lb plus 60 degrees
4. Tremec to rear bell housing? 45-65 ft lb

Thanks much

You should double check with FRPP re blue locktite however the torque specs they provided me are listed above

[DANW]

Thanks Jester, did they say what to torque the fly wheel down to? Also I am not sure what you mean by torque the pressure plate down to 33 ft lbs plus 60 degrees, I have read that before and not sure what the 60 degrees means.
Thanks.

[Jester]

Thanks Jester, did they say what to torque the fly wheel down to? Also I am not sure what you mean by torque the pressure plate down to 33 ft lbs plus 60 degrees, I have read that before and not sure what the 60 degrees means.
Thanks.

The plus 60 degrees means that you torque to the required setting then add an additional +60 degree turn to the bolt

Torque to for the flywheel to the crank is 80 ft lbs

[DANW]

Thanks and Happy New Year!!

[Jester]

Thx - Glad to help - good luck

Happy new year!