E-Ticket Ride
04-22-2012, 05:51 PM
Got my IRS center section installed yesterday, and planned on mounting the upper and lower control arms, axles, and knuckles today. I manged to get everything in up to the point of mounting and bolting up the knuckles, and discovered no hardware. Not sure if never seen, or I just misplaced it, but need some regardless.
Energy Suspension bushing ID is .554, so would a 14 mm be proper, or would 1/2" be fine?
Length of 3.5" looks correct (or metric equivalent).
I assume Grade 8, or metric equivalent, with flat washers on each outside, held together with nylock nuts and lock tight.
Thanks for any help on ID of the proper HW
Chris
Energy Suspension bushing ID is .554, so would a 14 mm be proper, or would 1/2" be fine?
Length of 3.5" looks correct (or metric equivalent).
I assume Grade 8, or metric equivalent, with flat washers on each outside, held together with nylock nuts and lock tight.
Thanks for any help on ID of the proper HW
Chris