1 ¾" Trim Rings for Breeze Roll Bars?

[Justin]

Mike Everson is no longer making these. Does anyone have a lead on some place that does?

[Mike.Bray]

If you don't find any it's an easy part to design and 3D print from aluminum.

[Dash]

what about getting 2 inch trim rings and getting a gasket that has a smaller inner diameter? Just a thought. Should be easy to acquire.

[cv2065]

I had some custom ones made for $85 as I wanted some that were a little oversized. Any metal fabrication shop could easily do these. Just give them the dimensions. Then get yourself a 1/16” thick rubber sheet off Amazon and make your gaskets.

[Justin]

I might do this. I can model the part myself and outsource the print.

[Mike.Bray]

I might do this. I can model the part myself and outsource the print.

craftcloud3d.com is the best place.

[Wingman06]

I used Send Cut Send sendcutsend.com It was very simple then I powder coated them chrome and it came out great. You can check out this video and jump to 6:30 and it will show what I did. https://youtu.be/jmd8d_3C8hE

[Mike.Bray]

I have the Breeze bar and had the same issue with the rear trim ring. I thought about laser cutting but went with printing as I wanted nice uniformed radius edges. Perhaps it's 6 one way and half a dozen the other. Since it's printed from aluminum it polished up real nice.

228469

228470

[hinoonaz1]

Mike Everson is no longer making these. Does anyone have a lead on some place that does?

I had 4 sets waterjetted. Then powder coated matt black for two and two silver. Uner 100 total cost. I have duel roll bars.