Sourcing 10-32 Adapters for Swaged Barrel and Ball-End Throttle Cables

[bcorner]

Hardware Identification Help Needed

I am currently working on my Type-65 Daytona Coupe build, and I've hit a wall with the throttle linkage. I have a universal throttle cable with pre-swaged ends and a set of quick-release ball joints (10-32 female threads), but I'm missing the "connectors" to bridge the two. The manual wants me to cut off the ends. But I would rather keep those pre-swaged ends in place.

Current Setup:

Cable Ends: 5.6mm (7/32") Barrel and 9mm (3/8") Ball Shank.

Linkage Hardware: Quick-release ball joints with 10-32 female threads.

What I'm looking for: I need the specific names or part numbers for the retainers that capture these fixed ends and provide a 10-32 male stud.

Specifically:

A slotted barrel retainer/clevis for the carb end (5.6mm).
A keyhole ball-end adapter for the pedal end (9mm).

Most "solderless" kits I've found assume bare wire, but I want to retain these factory-swaged ends. If anyone has a lead on where to find these on Summit, Amazon, or a marine supply shop, I'd appreciate the help!

[PNWTim]

Have you looked at McMaster-Carr? Or possibly Pegasus? A picture would help.

[narly1]

I believe what you are looking for is called a ball stud.

225407

Earl

[bcorner]

This is my cable:225450
These are the throttle disconnects I have. 225451
I have only found one picture of what I think of as a berral receiver. 225452

[Papa]

Check out this page from Summit Racing https://www.summitracing.com/search/brand/lokar/product-line/lokar-cable-fittings/part-type/cable-ends?fr=part-type&ptr=cable-ends&ptr_oos=1&sortby=default&sortorder=ascending&utm_source=bing&utm_medium=cpc&utm_term=lokar products&utm_content=lokar&utm_campaign=%2fapphome%2flanding d - l %28search%29

Also on Amazon: https://a.co/d/02YzpHov

My recommendation would be to buy a complete Lokar cable. The quality is far superior to what FFR provides and it comes with all the cable end parts and a swaged ball and clevis on the pedal end.

https://a.co/d/0gjCzkl7

[bcorner]

What length cable do you think? I went with the blueprint Ford 347 c.i. Carbureted.

[Papa]

This is the cable I'm using...

https://a.co/d/0acngNMK

I also found that this throttle linkage bracket works well with the Sniper...

https://a.co/d/09Ebcy2M

[David Ferguson]

Go to place in the race car world is California Push-Pull, Chico California. They have all the bits you need, good pricing and excellent service:

https://push-pull.com/streetrod/

[PMD24]

I went with the Lokar 48". That's a foot longer than the kit supplied cable. This will allow you to create much smoother bends with longer radii. The bends are where the friction occurs. At the engine I went with the Lokar billet aluminum bracket. For me personally I preferred this look over the flat bracket. You'll be impressed with the Lokar products.

225792

225793