Fuel filter suggestion for in-tank pump

[Stangrob]

Hi gents,

I've been looking at a number of options but figured this would be a good question to run by the collective group.

For my 331 build I'll be running a Pro-Flow4 setup and a Holley Sniper in-tank pump (12-345). I need a filter for between the pump and injection setup, and there are LOTS of options. What did you guys go with your setups?

Thanks!

Rob

[gbranham]

Aeromotive 12317 for my ProFlo4 and 427 SBF setup.

Greg

[Mike.Bray]

This one will work fine and not break the bank.

https://www.amazon.com/dp/B0FBGJD87M/?coliid=I2B3DCPW1X65ZT&colid=2IP8X5I5IP67Y&ref_=list_c_wl_lv_ov_lig_dp_it&th=1

[rich grsc]

I'll agree with Mike, no need to spend a fortune on a fuel filter. Some new factory cars don't even have fuel filters

[kirby]

I used the Corvette z06 style filter and regulator. They are inexpensive and available. I am pretty sure that they are set to 58 psi vs the 60 most systems call for but has not given me any trouble on my coyote.

Example: https://www.summitracing.com/parts/sum-230150/make/chevrolet/model/corvette/submodel/z06

[CW_MI]

Aeromotive 12317 for my ProFlo4 and 427 SBF setup.

Greg

I also went with this one.

[Stangrob]

Thanks guys - this was very helpful - I appreciate the input!!!

Rob

[Dgc333]

I used the Corvette z06 style filter and regulator. They are inexpensive and available. I am pretty sure that they are set to 58 psi vs the 60 most systems call for but has not given me any trouble on my coyote.

Example: https://www.summitracing.com/parts/sum-230150/make/chevrolet/model/corvette/submodel/z06

I too used the Corvette filter regulator for my Hemi installation with my Walbro inline pump. I purchased a Wix brand filter. It works well an maintains 58 to 60 psi across the rpm range.