KRC Hardware Question

[PNWTim]

Can anyone tell me what the exact size and style the 5/16" bolts are that hold the pump to the bracket? My kit had the hardware packet open and these bolts were missing. I also believe the spacers are incorrect for the Gen 4 engine but going to call KRC on Monday to confirm. I know Chris had to use a shorter spacer so there is definitely a disconnect.

[edwardb]

Sorry can't help with the hardware. KRC should be able to answer. Several have posted there is an issue with the spacers on the Gen4 Coyote. Supposedly a fix underway or even available.

[PNWTim]

Sorry can't help with the hardware. KRC should be able to answer. Several have posted there is an issue with the spacers on the Gen4 Coyote. Supposedly a fix underway or even available.

Thanks. I was planning on calling them tomorrow morning for both reasons. There is an issue with the spacers (they are incorrect) but I was flat out missing the pump bolts. I was going to correct the spacer issue myself but I didn't want to simply install any old bolt hoping it was OK. I am sure they will be able to address both issues in the morning.

[Pizzman76]

Thanks. I was planning on calling them tomorrow morning for both reasons. There is an issue with the spacers (they are incorrect) but I was flat out missing the pump bolts. I was going to correct the spacer issue myself but I didn't want to simply install any old bolt hoping it was OK. I am sure they will be able to address both issues in the morning.

I ran into this post on my way to ask the same question. I started to assemble the pump to my Gen 4 Coyote, and discovered the upper spacer was not the correct length. Here are my findings while looking at this issue for a bit today.

1. The kit comes with two 1.1" spacers and one 1.2" spacer. The outboard attachment should have the 1.1" and the inboard needs to have the 1.2" spacer. <-- This alignment will square the power steering and new water pump pulley perfectly. However, the upper spacer is much too long; I measured the gap on my motor at 0.61".
2. I also thought my two attachment bolts for the pump to the pump bracket were missing. It turns out they added the bolts in a bag with my power steering lines. I hope this helps!
222192222193

[PNWTim]

I ran into this post on my way to ask the same question. I started to assemble the pump to my Gen 4 Coyote, and discovered the upper spacer was not the correct length. Here are my findings while looking at this issue for a bit today.

1. The kit comes with two 1.1" spacers and one 1.2" spacer. The outboard attachment should have the 1.1" and the inboard needs to have the 1.2" spacer. <-- This alignment will square the power steering and new water pump pulley perfectly. However, the upper spacer is much too long; I measured the gap on my motor at 0.61".
2. I also thought my two attachment bolts for the pump to the pump bracket were missing. It turns out they added the bolts in a bag with my power steering lines. I hope this helps!
222192222193

Thanks for responding to this. I have my pump mounted and purchased bolts. If those came with my lines (which are hanging on my wall currently) I misplaced them from the git.

[dr-sicel]

Sorry can't help with the hardware. KRC should be able to answer. Several have posted there is an issue with the spacers on the Gen4 Coyote. Supposedly a fix underway or even available.

It’s been “supposedly” under development since late spring.’

Not available as of my last check