Precision Cut Dashes for MK3.1 and MK4

[ClemsonS197]

Edit: I'm going to pass on offering this service. Lack of interest, and a busier life don't make it worth pursuing. If you need dash help, shoot me a PM and I can help on a case-by-case basis. Thanks.

[ClemsonS197]

Well, as a sample here's what I'd send you...

The first document is actual size gauges based on two Autometer "Ultra-Lite" sizes, plus the "Cobra" series from Autometer. Just cut these out and tape them to your dash to figure out how your want your gauges placed.

http://img.photobucket.com/albums/v296/FinlayZJ/Dash2.jpg

The second document is a 1/3 scale dash with grid and 1/3 scale gauges. Once your full size mock up is done, mock up this 1/3 size dash and mail it back or scan it for me to send to the water jet.

http://img.photobucket.com/albums/v296/FinlayZJ/Dash1.jpg

[Gopher]

Nice Idea wished you offered this a couple of months ago. Best of luck to you.

[riptide motorsport]

Well worth it, greAt idea!

[ClemsonS197]

Well, I had a little interest, but nothing solid. I went ahead and made my own dash using the templates I created. Here's the gauges mocked up:

http://img.photobucket.com/albums/v296/FinlayZJ/Factory%20Five%20Roadster/photobucket-20039-1334712730424.jpg

[skullandbones]

If you are still interested in the project, I could be on a list for the next group. I am not going to use the dash for this initial phase but I would like to rearrange the gauges later and add a few. My plan is to put a tooling pattern on the new dash and the top of the transmission tunnel. Thanks, WEK.