Momo Steering Wheel Horn Button Placement

[cv2065]

My steering boss is drilled to accept the 6 screw Momo pattern and fits great but the Momo sized horn button will not fit into the boss. I thought about using the Momo horn adaptor plate and just shaving off the high side on the back, but that is where the button latches on. Then I started looking at the top side aluminum trim rings but not sure exactly how the horn would fit into that as I'm going to have an NRG quick release steering wheel and the adaptor plate, although would have clearance, won't sandwich in between the wheel and release.

Anyone have a Momo wheel and how you worked out the horn button? My horn is actually going to be on the i.e.427 turn signal stalk, so this will be more for looks to hide the mounting screw.

[i.e.427]

Chad, I could probably talk to our 3D print guy and see if he could come up with a cover that would snap into the steering wheel. No Idea what it would cost for a 1 off piece but?

Frank

[cv2065]

Chad, I could probably talk to our 3D print guy and see if he could come up with a cover that would snap into the steering wheel. No Idea what it would cost for a 1 off piece but?

Frank

Hey that’s a great idea Frank. Can you PM his contact info and I’ll reach out. Thanks!

[Jimmy B]

I am also running a MOMO wheel and haven't gotten to the horn yet so I am interested as well.

[Mike.Bray]

I designed a center cap and had it 3D printed in aluminum. Didn't turn out too bad. https://craftcloud3d.com/

216499