Turn Signal relay

[Buzzsaw]

How do I remove the turn signal relay? I am driving the car for a 250 mile shake down before I do the body work and paint it. Have 120 miles on it, all is working fine I thought. A friendly driver pulled up and asked about the car and was very enthusiastic about it. He mentioned my brake lights weren’t coming on until I was at a full stop. I thanked him. This afternoon I was trying to adjust the brake lights switch and some how I caused a major spark event. Yes, I know I should have disconnected the battery. After the sparks I have no brake lights or turn signals. I found the 15 amp brake fuse blown. I would like to check the turn signal relay before I pull the dash to check the self canceling motorcycle module I am using for turn signals, but pulling straight down does not release it. I don’t see a release lever and I don’t think it’s held in by screws. I am little hesitant to try to pry it out with a screwdriver. Any help would be appreciated.
Thanks Ross