kcwitt
06-11-2025, 11:44 PM
I have aGen3 Coyote. Ran great for 2500 miles then all this started.
I started getting the P0507 code & the engine went into limp mode.
Cleared the code twice.
Scheduled a tune & before I got to the tuner I had the engine throw the code again along with P061B.
Went to the tuner & cleared the codes.
I had a smoke test done initially & found a vacuum leak in the drivers side PCV hose to the air intake.
I have replaced that.
Did a couple of runs & a few adjustment.
Tuner said he disabled the P0507 code that would put the engine into limp mode.
Worked for about a week then threw the codes again.
Went into limp mode again
Went back & tried another adjustment to the tune & went for a couple days with no problems.
Now I am getting the P0507 code along with a new code. P062A
Went back to the tuner & was told that code was an electrical issue.
I looking for any suggestions.
I know there are at least a dozen possible causes.
Anyone else have any similar issue?
I started getting the P0507 code & the engine went into limp mode.
Cleared the code twice.
Scheduled a tune & before I got to the tuner I had the engine throw the code again along with P061B.
Went to the tuner & cleared the codes.
I had a smoke test done initially & found a vacuum leak in the drivers side PCV hose to the air intake.
I have replaced that.
Did a couple of runs & a few adjustment.
Tuner said he disabled the P0507 code that would put the engine into limp mode.
Worked for about a week then threw the codes again.
Went into limp mode again
Went back & tried another adjustment to the tune & went for a couple days with no problems.
Now I am getting the P0507 code along with a new code. P062A
Went back to the tuner & was told that code was an electrical issue.
I looking for any suggestions.
I know there are at least a dozen possible causes.
Anyone else have any similar issue?