Sandwich Plate For Oil Pressure and Temp

[FredG]

Hey Y'all,

I am doing a 289, that is carbed 5.0 done up like a 60's motor.
I wanted to put a sandwich plate in for the oil sensors.
If anyone has done this could you let me know which one you used? There are many and with slight differences.
Thanks so much!
Fred

[gbranham]

Yep, I did this on my 427 stroker. Bought it on Amazon. See my build thread, post #183 for pics. Gbranham's MkIV 427/IRS/TKX Build Thread...Expansion Tank Installation - Page 5 (https://thefactoryfiveforum.com/showthread.php?46723-Gbranham-s-MkIV-427-IRS-TKX-Build-Thread-Expansion-Tank-Installation/page5)

And here's the link on Amazon. https://a.co/d/3UWidmh

Greg

[Bob Cowan]

I purchased one from Summit Racing, made by Earls. It was billet, and not cast. It had one hole drilled and tapped for a sensor. It was pretty easy drill and tap a second hole.

[GoDadGo]

I used a CVR oil cooler sandwich adapter that I drilled out to open it up.
I only used one of the holes and capped off the other.
The link listed below is the Ford Version:

https://www.summitracing.com/parts/cvs-ocs64

Hope This Helps Give You An Additional Option!

[FredG]

I was looking at that one yesterday, it is not available any long .. but thank you! :)

[FredG]

I looked at that one as well and was trying to find one to avoid drilling more. I am trying the other one first to see if it works out.
Thanks!

[FredG]

Pictures are great!
I ordered this one to see if it works out.
Thank you.