Tilton mounting bracket

[ThickCobra]

I’ve not been on the forum in a while. Thought I’d start with a simple question. I’m installing the Tilton three in one brake and clutch reservoir and I’m looking for fabrication ideas for a bracket for the MK 4.

[OB6]

I just used some 1/8" aluminum and made a simple bracket. The bolts are what I had at the time and certainly don't need to be that long. :)

https://thefactoryfiveforum.com/attachment.php?attachmentid=190396&d=1695577402

[ThickCobra]

Do you know whether the hood would fit on the car if I were to raise that reservoir up to where the bottom of the caps are level with the frame member?

Jay

[GoDadGo]

I made a couple of aluminum flat bar brackets that attach to the upper and lower 3/4" tube.
Taking this action allowed me to easily route the reservoir lines to the master cylinders
You can see what I did between 8-30 seconds into the video linked below.
Just make sure it sets off enough to clear the body and the hood.

https://youtu.be/_wnHDNgnNqs

Hope This Helps & Good Luck!

[ThickCobra]

Both great bracket ideas.