Spanner Wrench Fit For Koni Coil Overs?

[Doc76]

Can anyone share a specific wrench that fits the Koni's?

I have two, one of which is adjustable, however neither fit

[GoDadGo]

I got this one from Speedway Motors that works fine on my RED-KONI's.

https://www.speedwaymotors.com/Speedway-Coil-Over-Spanner-Wrench-Adjuster-Tool,2681.html

Have A Happy Hanukkah & Merry Christmas!

Hope This Helps!

[rich grsc]

NON are needed. You adjust them with the spring tension OFF

[phileas_fogg]

As Rich says, a wrench is generally not needed. But one time I had a shock sag enough that I needed the wrench to get back to ride height.

A Williams 0-472 works perfectly. I got mine from Mark Reynolds at Breeze.


John

[Papa]

Looks similar to what I bought. https://www.amazon.com/gp/product/B001CC5A0U/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

My rings were stubborn, even unloaded, and this tool worked perfectly to get them to turn without damaging anything.

[Higgybulin]

Definitely take the load off the springs but if they are still a little stubborn, stick the short end of an Allen key in the hole and give'r a tug.
Higgy

[Doc76]

Thanks guys
Yup I have a couple that are stubborn. Is there a rule of thumb with a Ford 8.8 solid rear with front FFR suspension that can be kept in mind one can expect to see for turns of the nut vs height?
Ie, 1 full turn should see 1/8” rise or drop, etc.


Cheers

[FFinisher]

Factory Five has provided one with their kits for years. It is a bare metal thing with a tab on it, and hole on one end. It doubles as a Rivnut setter. I know this sounds goofy., but it is actually true.