Rebostar
11-15-2024, 07:17 PM
Today I decided to see if I could fit the Metco Drive Shaft Loop using an alternate mounting method. I saw AAron use the webs on the rear of the 4" tube and I wanted to do something similar. I started with a light cardboard cut out to see what would fit. Then I transfered that to 3/16" steel. I bent the first set of angles with a vice and torch. For the second angle I cut off the section and welded it back on at the correct angle. So now I had a base to attach the hoop to that would bolt to those angle webs. Then I mocked up the hoop and cut off the mount section that I needed. I clamped that in place to make sure everything would clear. Then I welded that section onto the previous piece. Looks like it will clear all the E-brake cables and pulley. Tomorrow I will drill the mounting holes to attach it to the car. I will weld on a pair of nuts on the inside of the upper flanges so It can be un-bolted. I will also put the rear axle on jack stands to make sure I have all the clearance I will need though all the suspension travel.
I'm sure this has been done a few times before, but on the other Metco thread I did not see or hear anything about it except what I posted about AArons installation. So here is my alternative method of attachment.
Happy Trails
206453206454206455206456206457206458206459206460
I'm sure this has been done a few times before, but on the other Metco thread I did not see or hear anything about it except what I posted about AArons installation. So here is my alternative method of attachment.
Happy Trails
206453206454206455206456206457206458206459206460