Any reason I can't put tail light converter here?

[Mat1asBEV&ICE]

Figured it would be easy to reach and replace if need be. I am guessing it's okay if it were to get a little bit wet. I have already connected back here so behind the dash is not an option.

Thank you.

https://thefactoryfiveforum.com/attachment.php?attachmentid=200600&d=1718057653

[JJK]

if it ever needed maintenance not sure you could get to it there unless you dropped the fuel tank

[BUDFIVE]

I put mine by the fuel tank sending unit and have access through the trunk floor. It’s shown in my build thread entry #35.
https://thefactoryfiveforum.com/showthread.php?47734-BUDFIVE%92s-CenTex-Build-Radiator-Cables-more

[Mat1asBEV&ICE]

Thank you, I should be able to put mine by the in-tank fuel pump and access that way. I have a lower trunk mod so it won't reach over there.

BTW, where did you get those switches for the dash? I like them.

[AROCK]

I put mine over fuel tank, under an access panel. Easy peasy. I have a drawing of the circuit if you would like it.

[Mat1asBEV&ICE]

Thank you. I decided I will use the 3M dual lock I have to stick it to the bottom of the fuel pump access panel. I think that will work well as there’s plenty of slack on the wires.

[BUDFIVE]

Thank you, I should be able to put mine by the in-tank fuel pump and access that way. I have a lower trunk mod so it won't reach over there.

BTW, where did you get those switches for the dash? I like them.
Thanks-The switches are Carling LT-1511-640-012 Lighted on/off but the decorative stainless toggle nuts holding them are #100023 from New Wire Marine.

[rich grsc]

Why not put it in the wheel well where many put it?

[Mat1asBEV&ICE]

Thank you, I had not seen/read that solution. I'll check it out.