TH 350 in hot rod

[Ltfracing]

Has anyone put a TH 350 in a 33 hot rod,any modifications that need to be done to the crossmember ,thank you

[cvacca]

Yes, going old school, I like that! Installed mine a few years back. Nothing to special. Mounted the crossmember upside down and used 1/2" spacers to get the angle I was looking for to mate to the IRS.

[Ltfracing]

Do you have any pictures of how you installed it sir

[cvacca]

198608198609
Sure, here are a couple.

[Ltfracing]

Did you have to do anything to your driveshaft sir

[cvacca]

No, I was able to use the one FF supplied with the kit when I told them I was installing a SBC383 w/ a TH350. I installed a Holley Sniper EFI with their Hyperspark distributor which is smaller than most so I was able to slide the engine and tranny back a little more to help with the engagement with the driveshaft.

[Ltfracing]

Thank you sir,do you remember the parts # of the driveshaft they sent you any chance you could give me a measurement of it,thank you sir

[cvacca]

FF part # 34048 which I believe is 31" long. My transmission tail shaft is 6" long and I believe 27 spline. If I remember right, I also bought a longer slip yoke from Denny's Driveshafts so to have better engagement into the tranny. I didn't figure that out until I had the tranny and IRS mounted that I realized the slip yoke would be to short. I read somewhere that you want it to engage 1" shy of bottoming out inside of the tail housing.
Hope this helps.

[Ltfracing]

217830217831
So installing a th350 in 33 my left side bolt hits the trans case,second picture is of gentleman who installed a th350 in his 33 and it doesn’t hit,talked to FFR and there answer was to buy a new mount,lol im using the one supplied with the kit for a SBC install ,how is buying a new mount going to fix that

[Just 1 More]

700R4 and I flipped that FFR bracket up, no trans mount spacers, std GM trans mount.

[Ltfracing]

Any chance you can take a picture sir,thank you

[Just 1 More]

Any chance you can take a picture sir,thank you

I'm sure I can slither under there and snap a few later today

[Ltfracing]

Thank you sir,much appreciated

[Just 1 More]

Thank you sir,much appreciated

Does this help?
218024218025

[Ltfracing]

Yes thank you so much,so you didn’t use the adapter bracket,bolt mount directly to trans

[Ltfracing]

218463218464218465
I figured it out,bought a lathe and made the parts I needed