Hyraulic clutch bulkhead pass through?

[CptMorgan]

I have the Wilwood / FFR factory hydraulic clutch. It comes with a short hose.

How am I supposed to run this through the foot box wall? Am I missing a bulkhead fitting?
Is there supposed to be a cover or seal for this hole?


196966

Thanks.
-Morgan

[Mat1asBEV&ICE]

People usually run the hoses for the brake and clutch reservoirs thought that hole and buy a grommet to seal around the hoses and the hole.

The hydraulic clutch hose is usually run through the inside panel of the footbox (use another grommet), down to the transmission.

[cc2Arider]

Cap'n,

I think most builders drill a pass-thru on the inner driver's side footbox panel. I've also seen clean installations pointing downward when using a forward firewall panel (FFMetals). I'm planning a different layout since I'm going to make a central console (and I can hide the pass-thru in there).

Craig C

[JJK]

As Mat1 said , the hole in the front of the pedal box is often used for the brake and clutch hoses to the reservoirs. I used a 90 bulkhead fitting on the engine side of the pedal box to run the clutch line down to the transmission

[edwardb]

Just to be clear -- direct answer to your question: No, don't run the connection from the hydraulic MC to the clutch slave through that hole in the front of the footbox. A much more direct route is through the side or bottom of the footbox as others have suggested. I use the same hole as the one for the rear harness.

[Mike.Bray]

I did a -3 AN bulkhead fitting through the side of the footbox.

https://www.imagecoast.com/images/MichaelBray1/20220623151832mediumrotated.jpg

[F500guy]

I ran my line under the square dash tube
196986196987

[CptMorgan]

Perfect. Thank you!

I'll block off that hole, buy a bulkhead fitting and run it out of the footbox inside.